Operating instructions

The “Density” application
111
10.3 Settings for the “Density” application
For the determination of density, various specific settings are available which you can use to adapt the application to your require-
ments.
10.3.1 Overview
“Method”: In this menu you can select the type of density determination.
“Auxiliary liquid”: In this menu you can specify the auxiliary liquid you want to use.
“Statistics”: In this menu you can activate or deactivate the statistics for the selected method.
“Results Output Format”: In this menu you can specify how the result of the density determination should be cal-
culated and displayed.
“Function Keys”: Several special function keys for density determination are available.
“Info Field”: Additional information fields for density determination are available.
“Protocol”: Additional information about density determination is available for reports.
“Smart & ErgoSens”: The sensors can be given special functions for density determination.
In the following sections you will be given a detailed introduction to the specific settings for the “Density” applic ation.
10.3.2 Selecting the method for density determination
In this menu you can specify the type of density determination you want to perform:
The application-dependent settings can be accessed with the «E» key.
Some of the settings for the “Density” application are identical to those for the “Weighing”
application (section 5.2). Only the settings which are different are described below. These
settings are contained in the following menus:
E
“Solid body”: Density determination of non-porous solid bodies using an
auxiliary liquid.
“Liquid”: Density determination of liquids using a sinker.
“Pasty substance”: Density determination of pasty substances using a gamma
sphere.
“Pycnometer”: For determining the density of liquids using a pycnometer.
“Solid porous”: For determining the density of porous solid bodies by using a
supplementary oil bath.
Factory setting: The “Solid body” method is activated.