Operating instructions

The “Dynamic Weighing” application
131
11.3.7 Special report information for dynamic weighing
In the three submenus where you can specify the options for the header line of reports,
the options for individual values, and the options for the results, there are additional set-
tings available which are described below.
Note: All other items of information in the reports are the same as for the “Weighing”
application (section 5.2.8) and are not listed here.
11.3.6 Special information fields for dynamic weighing
In the menu for info fields the following special settings for dynamic weighing are available:
“AutoStart”: Indicates whether the “AutoStart” function is active (section
11.3.4). If the function has been activated, the associated
minimum weight is displayed.
“Status”: Current status of the application (for explanation see section
11.4.1).
The following information fields are only relevant if the statistics function has been acti-
vated (section 11.3.11):
“n”: Number of samples weighed.
“x”: Average (mean) weight of all samples.
“s” and “s.rel”: Standard deviation as absolute value and percent.
“Min” and “Max”: Lowest and highest weight values in the current measurement
series.
“Diff”: Difference between lowest and highest weight values.
“Sum”: Accumulated value of all individual weighings.
All other information fields are identical to those for the “Weighing” application (section
5.2.4).
Factory setting: “AutoStart”, “Status” and “ID1” activated.
11.3.5 Settings for the beep at the end of the measurement cycle
In the “Beep” menu you can specify whether a beep should indicate the end of a measurement cycle.
“Off”: There is no beep at the end of a dynamic weighing.
“On”: As soon as the result of a dynamic weighing is ready, a beep
is emitted. If you switch the beep on, after you have started a
weighing cycle you can do another job until the beep tells you
that the result is ready.
Factory setting: “On” (beep switched on)