Operating instructions

The “Dynamic Weighing” application
132
Report header line
On the second page of this submenu there are further settings for dynamic weighing:
“AutoStart”: Reports whether the “AutoStart” function is active (section
11.3.4). If the function is activated, the associated minimum
weight is printed out.
Factory setting: “Appl. Name” (“Dynamic Weighing”) and “Date/Time” (in this
order). No specific information items for dynamic weighing are
activated.
If the header line has been defined as a component of the weighing report, it is printed
automatically (see “Reporting individual values”). The header line can also be printed out
separately by pressing the “Header line” function key.
Reporting individual values
On the first page of this submenu the following special settings for dynamic weighing
are available:
“AutoStart”: Reports whether the “AutoStart” function is active (section
11.3.4). If the function is active, the associated minimum
weight is reported.
“Sample”: Reports the net weight value of the current weighing.
Factory setting: “Sample”.
An individual value is printed out either by pressing the «F» key with the result window
open, or automatically (see section 11.3.8).
Footer line of the report
On the second and third pages of this submenu you can specify additional statistical
information which should be printed out in the footer of the weighing report after the
results (individual values):
“n”: Number of samples weighed.
“x”: Average (mean) weight of all samples.
“s” and “s.rel”: Standard deviation as absolute and percentage value.
Note: These two values are only reported if the statistics contain
at least 3 values, otherwise horizontal lines are printed instead
of the values.
“Min, Max, Diff.”: Lowest and highest weight values determined in the current
measurement series and the difference between these val-
ues.
“Sum”: Accumulated weight of all individual values saved.
Factory setting: “Dash line” and “3 Blank Lines”; no specific information items
for dynamic weighing are activated.
The footer line is printed out when the “Footer” function key is pressed.
You will find an example of a dynamic weighing report in section 11.4.4.