Operating instructions

The “Dynamic Weighing” application
137
11.4 Working with the “Dynamic Weighing” application
In this section you will learn how to work with the “Dynamic Weighing” application. It goes without saying that you can change the
resolution of the weighing result (e.g. to speed up the weighing operation), work with identifications, etc. Since you already know about
these possibilities from the “Weighing” application (section 5.3), they are not explained again here.
11.4.1 Dynamic weighing with automatic start
Settings
To perform a dynamic weighing with automatic start, you must have activated the “AutoStart”
function and specified the corresponding minimum weight (section 11.3.4). No special
function keys need be activated, but we recommend you to switch on the “ID” function key
if you want to assign an identification to each sample. Both of the required information
fields, “AutoStart” and “Status”, are already activated at the factory (section 11.3.6).
Performing the weighing
Make sure that the “Status” information field is displaying “Ready”. If it is displaying “Not
ready”, wait until the display is stable and the status changes to “Ready”. If “Please Zero”
is displayed, press the «G» key.
If you work with a weighing container, place the container on the weighing pan and press
the «H» key to tare the balance. If you want to give the weighing object an identifica-
tion, press the “ID” function key and enter the desired identification (alternatively you can
read the identification in with a chip scanner).
Place the weighing object on the balance. The weight of the weighing object must be greater
than the weight shown in the “AutoStart” information field, otherwise the weighing cycle
will not start automatically. After the automatic start, the window shown at left appears.
When the weighing is finished, the result is displayed along with a prompt to remove the
weighing object.
If automatic reporting of the individual values is activated (section 11.3.8), the result of
the weighing is printed out automatically. To print out the weighing result manually, press
the «F» key.