Operating instructions

The “Differential Weighing” Application
144
The printout header
An additional setting for differential weighing is available on the second page of this
submenu:
“Series ID”: Prints the ID of the selected series.
Factory default setting: “Appl. Name” (“Differential Weighing” is printed) and “Date/
Time” (in this order); no specific information is activated for
differential weighing.
Printing protocols for single values
The following specific settings are available for differential weighing on the first and
second pages of this submenu: These settings define which additional information is
printed for each sample:
“Series ID”: Prints the series ID.
“Sample ID”: Prints the sample ID.
“Tare time”: Prints the date and time at which the tare value was record-
ed.
“Tare”: Prints the tare weight value.
“Weighing in ti...”: Prints the date and time of weigh -in.
“Weighing in”: Prints the initial weight value.
“Time 1 res.wgh”: Prints the date and time of the first residual weight.
“1. Residual wgh”: Prints the weight value of the first residual weight.
“Time 2 res.wgh”: Prints the date and time of the second residual weight.
“2. Residual wgh”: Prints the weight value of the second residual weight.
“Time 3 res.wgh”: Prints the date and time of the third residual weight.
“3. Residual wgh”: Prints the weight value of the third residual weight.
Factory default settings: “Sample ID”, “Tare”, “Weighing in” and “1. Residual wgh” (in
this order).
12.3.4 Specific Protocol Information for Differential Weighing
The five submenus in which you can select
options for records contain additional set-
tings for differential weighing. These are
described below. For further information
on protocol settings, please also refer to
the settings in the “Print Key” menu (sec-
tion 12.3.5).
Note: The other available protocol information
is the same as for the “Weighing” application
and is not described here.