Operating instructions

The “Differential Weighing” Application
155
12.5.6 Additional Options
This section describes some further functions of the “Differential Weighing” application.
Deleting a single value
If you realize immediately after entering a value (tare, weigh in, residual weighing) that you
have made a error, you can delete the last entered value using the “CL value” function
key. However, this is only possible if no menu has been called, and if you do not exit the
application in the meantime. The last value that was recorded can also not be deleted
after you change the sample or the series.
Deleting all values for a sample
If you have made an error in differential weighing, you can delete all measured values
for a single sample.
Before you can delete the values for a sample, the “CL Sample” function key must be
activated (section 12.3.2).
After pressing the “CL Sample” function key, a selection window is displayed. Here you
can choose which sample you want to delete.
Before deletion, the balance requires you to confirm that you actually want to delete all
values for the selected sample. When you confirm the prompt, all available values for tare,
weighing in and residual weighing are deleted, and the sample ID is reset to the factory
default setting. Check the ID before continuing to work with this sample.
Note: The menu for the application-specific settings, includes a function for deleting a
whole series (section 12.4.3).
Attention: All series and sample are stored in a single database that is available to all
users. You can therefore also delete series and samples defined by other users. For this
reason, you should proceed with caution when deleting a series or sample, and consult
other users if necessary.
Copying the tare value
The “Copy tare” function key enables you to use the tare weight of the first sample for
all other samples in the series that do not yet have a defined tare value (existing tare
values are retained!). This can save a considerable amount of time if you use the same
tare vessel for all samples.
Note: The function key is inactive if no tare weight has been entered for the first sample,
or if all samples in the series already have a defined tare weight.