Operating instructions

The “LabX Client” application

157

13 The “LabX Client” application

This section provides an introduction to the “LabX Client” application. It provides information on starting the application and the setting

options. Please note that all settings for the “LabX Client” application are saved under the active user profile, so each user can

make their own settings for this application. Because of this, first make sure that you have selected the desired user profile.

13.1 Introduction to the “LabX Client” application

The “LabX Client” application registers your balance as a client in the “LabX balance” PC application (“LabX light balance” or “LabX

pro balance”). “LabX balance” enables the definition of complete dialog-controlled work processes for the balance, and can be used

to store and manage measured values and additional data in a database on the PC.

As soon as you have started the application, the balance establishes contact with “LabX balance” and following successful logon, the

PC application assumes control of the balance. The balance screen then displays the user navigation for “LabX balance”.

Since your balance is controlled as a “LabX Client” by the PC software, “LabX Client” only has a few application-specific settings.

13.2 Selecting the application

If the “LabX Client” application is not already active, press the «D» key. Choose the icon

for the application in the selection window.

Once the application has been selected, the balance tries to establish contact with the

“LabX balance” software on the PC. If logon is successful, the user navigation for “LabX

balance” is displayed. For all further instructions, refer to the operating instructions

for “LabX balance”.

Note: This application is not suitable for LabX 2010 or higher. In order for you to be able to use your balance

with this product, refer to section 3.7.

Attention: The “LabX” PC software is not covered in these instructions. For more information on working

with this software, see the separate operating instructions for LabX software.