Operating instructions

System settings
20
“Balance Info”
When the “Show” button is pressed, a window appears with information on the balance
and the built-in options. This information is of particular importance for the service techni-
cian. If you call the METTLER TOLEDO customer service department, you should have this
information at hand.
Balance information can be printed by pressing the «F» key (provided that a printer is
connected and activated as the output device in the peripheral settings).
3.5 Standby (energy-saving function)
This menu can be used to define the length of time that the balance must be inactive before it automatically enters “Standby” mode.
You can switch off standby mode (“Off”) or define a time of 30, 60, 120 or 240 minutes,
after which the balance should enter “Standby” mode. “Standby” mode is the same state
that the balance enters if it is switched off using the «On/Off» key. Press the «On/Off» key
to switch the balance on again.
Factory setting: “Off” (“Standby” mode deactivated)
Attention: In order for the balance to switch to “Standby” mode, no item should be on
the balance.
Note: Regardless of the “Standby” mode setting, the brightness of the display is automati-
cally reduced if the balance has not been used for 15 minutes. If the display value on the
display changes during these 15 minutes (e.g. as a result of vibrations), the balance will
wait another 15 minutes until the brightness of the display is reduced.