Operating instructions

User settings
33
4.5 Settings for the doors of the glass draft shield (Model-dependent)
In this menu you can adjust the function of the doors of the glass draft shield to your requirements
The following options are available:
“Door Function”
The automatic door function automatically opens and closes the doors of the glass draft
shield as soon as this is necessary.
Examples:
– When you press the «H» key, the doors open automatically to allow you to place
the tare weight on the pan.
– When you are prompted to place the adjustment weight on the pan while you are
adjusting the balance, the doors automatically open. As soon as you have placed the
weight on the pan, the doors automatically close again.
– The doors of the glass draft shield will close automatically whenever this is required
to reach a stable weight value.
– The doors open and close automatically during many work processes (e.g. piece
counting), depending on the current requirements of the application.
Manual door function: You will have to open and close the draft shield (doors) yourself
(using the «K», key, via SmartSens (section 5.2.17) or by hand).
Factory setting: “Manual”
“Doorway”
This setting allows you to define how wide the doors of the glass draft shield open (au-
tomatically or manually). If you select the 100 % setting, the doors will open all the way.
If you select “25 %”, however, the doors will open only a quarter of the way. Two other
intermediate settings can be selected.
If your application allows it, you can reduce the opening of the doors. This shortens the
opening and closing times, making environmental influences (drafts) less bothersome.
Factory setting: “100 %”
Depending on the model, there may be further or different settings for the door sys-
tems.
– Inner draft shield
– Outer draft shield
The procedure corresponds accordingly the door opening.