Operating instructions

User settings
35
“Color Selection”
This menu can be used to adapt the color of the display to your personal taste. However,
colors can also be used as a guide: if you use different colors for different user profiles,
you can see at a glance which profile is currently active. In total, there are 8 color palettes
to choose from.
Factory setting: Color palette 1 (blue with soft contrast)
Note: The color palettes in the left column offer a visually attractive appearance with soft
contrast, while the palettes in the right column offer a more contrast display for better
readability under poor light conditions.
“Sound”
Setting for the volume of the beep (range 0 % - 100 % in steps of 10 %). Setting at 0 %
switches the sound off.
Factory setting: 70 %
“Touch Function”
If you switch off the touch function for the “Touch Screen”, the display no longer responds
to touch in weighing mode and you can therefore no longer make settings by simply
touching the display (except for function keys). Important: The touch function is always
active in setting mode, as otherwise you would not be able to make settings.
Factory setting: “On”
“Touch Adjustment”
If you feel that the balance is no longer reacting correctly when you touch a specific part
of the display, you can adjust the “Touch Screen”. When the “Activate” key is pressed, a
window appears and you are asked to touch the flashing area. This operation is repeated
several times (it can be aborted at any time using the “C” key).
“Optical key feedback”
A short beep sounds to confirm each time a key is pressed or a menu function is carried
out. If you would like an additional optical confirmation, you can switch on the “Optical
key feedback” function. In addition to the beep, the yellow LEDs at the bottom left and
right of the status bar on the terminal light up briefly.
Factory setting: “On”
“Speedread”
When this function is activated, the weighing result is displayed in a lighter color while
it is unstable. When the result becomes stable, it is displayed in a darker color. If the
“Speedread” function is deactivated, the weighing result is always displayed in the same
color irrespective of whether or not it is stable.
Factory setting: “On”