Operating instructions

The “Weighing” application
41
When you activate the “AutoPrint” function (“On”), press “Define” to define the criteria for
automatic record printing:
“Limit”: For automatic record printing to occur, the weight value must
fall short of and then exceed the specified limit.
“Delay Time”: As soon as the limit is exceeded, the “Delay Time” starts. Once
this time has elapsed, the weight value is recorded and printed.
This setting allows the weighing result to be printed with a
defined delay, if necessary.
Factory setting: “Off” (automatic record printing is deactivated).
The following information fields are available:
“Nominal”: This information field shows the target weight that was entered through the function key
with the same name.
“+Tol” and “–Tol”: This information field shows the tolerances for weighing to a target weight, which were
entered through the function key with the same name.
“Lotcounter”: This information field displays the status of the item counter.
“ID1”, “ID2”, “ID3” and “ID4”: These information fields show the IDs entered via the “ID” function keys. Note: The defined
names are displayed instead of “ID1”, “ID2”, “ID3” and “ID4” (section 5.2.11).
“Info Unit”: This information field displays the weighing result in the second selected weighing unit
(section 5.2.6).“
“Tare”: This information field shows the current tare value (in the same weight unit as the weigh-
ing result in the main display).
“Gross”: This information field shows the current gross weight value (in the same weight unit as
the weighing result in the main display).
“Ref. Tare”: If the “MinWeigh” function is activated (section 5.2.14), this information field displays the
upper limit of the reference tare.
“MinWeigh”: If the “MinWeigh” function is activated (section 5.2.14), this information field displays the
required minimum initial weight value based on the reference tare.
“MW-Method”: If the “MinWeigh” function is activated (section 5.2.14), this information field displays
which of the three available MinWeigh methods used for QA standard.
Factory setting: No information fields activated.
5.2.5 Specifications for automatic record printing
This menu option can be used to specify whether and under which conditions the balance is to print the weighing result automatically.
The information defined for printing single values is printed (section 5.2.8).