Operating instructions

The “Weighing” application

5.2.18 Settings for the optional antistatic Kit (Model-dependent)

Settings for the optional antistatic kit eliminates the static charge of weighing material. The antistatic kit is connected to one of the

two “Aux 1” or “Aux 2” connections at the rear of the balance (both of these connections are also used for the optional ErgoSens). The

antistatic kit must be selected in the ErgoSens settings for the balance to recognize it (see section 5.2.17; also see the instruc-

tions supplied with the antistatic kit).

In this menu option you can make settings for the operating principle of the antistatic

kit.

The following settings are available:

“After door opened”: Here you can deﬁne whether ionization will occur when the

glass draft shield (doors) is opened (“Active”) or whether no

ionization will occur (“Inactive”). With the “Active” setting,

ionization will occur continuously until the draft shield (doors)

is closed again (a maximum of 10 minutes).

“After door closed”: This setting deﬁnes the number of seconds ionization should

occur after the draft shield (doors) close (adjustment range

0 ... 1000 seconds). Note: If you set it for “0” seconds, there

will be no ionization after the draft shield (doors) close

Factory setting: Ionization occurs when the draft shield is open (“Active”).

Ionization occurs for 5 seconds after the draft shield (doors)

close.

Note: If a function is activated, which emulates a key on the terminal, the relevant icon lights up below the corresponding sensor in the

status bar (“K”, “ G”, “H” oder “F”). For all other settings (that emulate function keys of the same name), the green “F” (function)

icon lights up. No icon lights up when the sensor is deactivated.

Factory setting Model-dependent: Precision balances: “Off” for all 4 sensors.

Analytical- and

Micro balances:

SmartSens left and right conﬁgured for draft shield (doors) opera-

tion. “Off” for both ErgoSens.