Operating instructions

The “Weighing” application
57
Once you have completed all the entries, you can check the selected IDs again using the
information fields in the display.
All ID text is stored until it is replaced by new text.
If the weighing record has been defined so that the IDs are also printed (section 5.2.8),
both the defined ID names (e.g. “Client”) and the text entered (e.g., “METTLER TOLEDO”)
will be printed. The illustration opposite shows a printout with the IDs from the example
above.
5.3.5 Weighing to a nominal value
The “Weighing” application offers you additional functions that simplify weighing to a defined target weight.
Presettings
The function keys shown at left must be activated so that a nominal weight and the
corresponding tolerances can be entered (section 5.2.2). To view the defined values in
the display, the information fields of the same name can also be activated, if necessary
(section 5.2.4).
Operating sequence
Press the “Nominal” function key. Type in the desired value. Check the weighing unit,
which is shown to the right of the nominal value. When the weighing unit is touched a
selection box containing the available units appears. Note: The units are not converted
automatically; i.e., if a value is entered in one unit, this value remains the same even if
the weighing unit is changed.
Once the value is entered, press “OK” to activate the nominal value.
The “+Tolerance” and “-Tolerance” function keys can be used to specify the accuracy
with which you wish to weigh. The input window is the same as for the nominal value.
The input window is the same as for the nominal value. Both tolerance values are set to
2.5 % ex works. Instead of a percentage value, you can also enter an absolute tolerance
in any weighing unit (e.g., “g”). Once the relevant value is entered, press “OK” to activate
the tolerance.
------- Weighing -------
16.Mar 2004 17:21
Client
METTLER TOLEDO
Order MT-18/2004
Lot 18/2B
Sample 1/4
N 242.83 g
T 20.76 g
G 263.59 g