Operating instructions

The “Formulation” application
76
7.3.4 Special information fields for Formulation
The following settings for formulation are available on the first two pages of the menu for information fields:
“Comp. Weight”: Current weight of a component.
“Nominal”: Shows the nominal weight of the current component entered
via the function key of the same name.
“Net Tot.”: Total net weight of all components that have been weighed
in.
“>T+” and “<T-”: Number of components outside the upper/lower tolerance
range.
“+Tol” and “-Tol”: These information fields show the tolerances entered via the
function keys of the same name.
“Comp. Counter”: Displays the current state of the component counter (number
of the current component).
“Recipe Name”: Name of the current recipe.
“Recipe ID”: Identification (ID1) of the current recipe.
“Comp. Name”: Name of the current component.
“Comp. ID”: Identification (ID2) of the current component.
“Lot ID”: Lot ID (ID3) entered via the “ID” function key.
“Additional ID”: Additional ID (ID4) entered via the “ID” function key.
Note: The names of the four IDs are specified ex works but can be changed (section
7.3.6).
All other information fields are identical to those of the “Weighing” application (section
5.2.4).
Factory setting: “Recipe ID”, “Tare”, “Gross” and “Nominal” are activated (in
this order)
7.3.3 Special function keys for Formulation
The following settings are available for Formulation in the function key menu:
“M+”: Stores the net weight of the weighed in components and resets
the weight display to zero.
“Result”: Opens the window with the results of the formulation.
“CL Result”: Deletes the stored values of a formulation.
“CL Last”: Deletes the last values of a formulation.
“Nominal”: For specifying the nominal weight for the current compo-
nent.
“+Tol” and “-Tol”: Defines the accuracy with which a component is to be weighed
in.
“Max n”: For specifying the maximum number of samples to be
weighed.
All function keys not listed are identical to those for the “Weighing” application (section
5.2.2).
Factory setting: “M+”, “Result” and “CL Result” are activated (in this order).