Operating instructions

The “Formulation” application
79
The following names for the 4 identifications are defined ex works:
“ID1” “Recipe ID”
“ID2” “Comp. ID”
“ID3” “Lot ID”
“ID4” “Additional ID”
Individual identifications can be deactivated or their names can be customized (maximum
of 20 characters). The entered names also appear as the names of the relevant information
fields (section 7.3.4) and are included on the weighing printouts (section 7.3.5).
Factory setting: “T1” and “T2” as the record titles
“ID1” activated, see above for name.
Note: The “Recipe ID” and “Comp. ID” are not required to automatically process predefined
formulae because they are transferred automatically from the formula or component
database. The other IDs can be activated should you want to enter additional IDs during
formulation. However, for free formulation (without using the database) the “Recipe ID”
and “Comp. ID” should be activated so that your formulae and components can be as-
signed a name.
7.3.6 Special identifications for Formulation
A maximum of 4 identifications, which should be available during formulation under the “ID” function key, can be activated and renamed
in this menu. In addition, two titles for the weighing records can be defined and printed in the weighing records.
7.3.7 Special SmartSens and ErgoSens settings for Formulation
Additional settings for formulation are available for SmartSens and ErgoSens sensors.
“Result” and “M+” emulate the function keys of the same name. “OK” emulates pressing
the button of the same name in the formulation dialog boxes (but not in the menus) to
confirm entries and actions.
Note: The settings “Recipe ID”, “Comp. ID”, “Lot ID” and “Additional ID” correspond to the
identifications ID1 ... ID4, which are also available in the “Weighing” application (section
5.2.17).
If one of the above settings is activated, the green “F” (Function) icon lights up below the
corresponding sensor in the status bar.
Factory setting Model-dependent: Precision balances: “Off” for all 4 sensors.
Analytical- and
Micro balances:
SmartSens left and right configured for draft shield (doors) opera-
tion. “Off” for both ErgoSens.