Operating instructions

The “Piece Counting” application
95
The three submenus for defining the record header, printing individual values and for the
result contain additional settings for piece counting, which are described below.
Note: The other available record information is the same as for the “Weighing” application
(section 5.2.8) and is not described here.
Record header
Additional settings for piece counting are available on the second page of this sub-
menu:
“Max n”: The defined maximum number of piece counts in a series is
printed.
“Nom.,+Tol,-Tol”: The defined nominal piece number and the selected tolerances
are printed.
Factory setting: “Appl. Name” (“Piece Counting” is printed), “Date/Time”, “Bal-
ance Type” and “Serial Numbers” (in this order); no specific
information is activated for piece counting.
The header is printed automatically when the “M+” key is pressed during a series of piece
counts to store the first count value. The header can also be printed separately by pressing
the “Header” function key.
Printing single values
The following special settings are available for piece counting on the first and second
pages of this submenu:
“Nom.,+Tol,-Tol”: The defined nominal piece number and the selected tolerances
are printed.
“RefPcs”: The selected reference piece number is printed.
“PcsWgt”: The recorded reference piece weight is printed.
“NetPcs”: The recorded net piece number is printed.
“Net”: The recorded net value in the current display unit is printed
and an item counter is placed in front of the value.
Factory setting: “ID1”, “Nom.,+Tol,-Tol”, “Net” and “NetPcs” (in this order).
A single value is printed automatically when the “M+” function
key is pressed during series counts. A single value can also be
printed separately by pressing the «F» button (in which case
no item counter is placed in front of the net value).
8.3.7 Special printout information for piece counting