User manual
IND445
16
Operation
User manual 22013194B 05/08
2.7.3 Weighing-in
1. Place the empty container on the scale and tare.
2. Fill the container with the weighing sample.
The dispensing process can be followed in the graphic display. The 50 % marking
is on the far left here, so that more display segments are available for precise filling
between 50 % and 100 %.
As long as the lower tolerance is not reached, the minus tolerance mark is dis-
played.
If the weight of the weighing sample is within the defined tolerance, the mark OK
is visible and a short beep sounds if activated in the menu.
When the plus tolerance mark appears, the weight is above the permissible toler-
ance.
2.7.4 Checkweighing
1. Place the weighing sample on the scale.
2. Use the displayed mark to check whether the weighing sample is below, within or
above the defined tolerance.
2.7.5 Clearing the saved target weights
1. Enter the number of the memory location with the target weight to be cleared (fac-
tory setting: 81 ... 90) and press briefly.
The saved target weight is displayed.
2. Press within 2 seconds.
CLEArED briefly appears in the display. The saved target weight is cleared.
2.8 Working with identifications
Weighing series can be assigned 2 identification numbers ID1 and ID2 with up to
40 characters that are also printed out on the protocols.
If for example a customer number and an article number are assigned, it can be
clearly seen on the protocol which article was weighed for which customer.
2.8.1 Entering identification
1. Enter identification and press .
IdENt 1 appears in the display.
2. If the entered identification is to be saved as ID1, press . If the entered identi-
fication is to be saved as ID2, first press , and then press .
The scale returns to weighing mode.
T