Specifications

Transmitter M300 FLOW 28
© 09 / 08 Mettler-Toledo AG, CH-8606 Greifensee, Switzerland Transmitter M300 FLOW
Printed in Switzerland 52 121 319
6 Quick Setup
(PATH: Menu/Quick Setup)
Quick Setup allows limited configuration of the most common functions of the M300 Flow
transmitter. Detailed information for each function can be found in the individual sections of
the manual.
6.1 Enter Quick Setup mode
Select Quick Setup and press the [ENTER] key. Enter the security code if necessary (see section
9.3)
C
Note: Refer to section 3.3 for information on menu navigation.
While in Measurement mode press the [MENU] key to bring up the Menu selection. Select Quick
Setup and press the [ENTER] key.
Convention:
1
st
line on display => a
2
nd
line on display => b
3
rd
line on display => c
4
th
line on display => d
Only lines a and b on single channel models or lines a and c on dual channel models can
be configured in Quick Setup. Go to the Configuration Menu to configure remaining lines.
6.2 Flow Sensor Type Selection
Refer to Section 4.5 for Flow sensor type information. Select the desired flow sensor type.
When configuring four channel transmitters, also select the channel A, B, C or D to be con-
figured. Press [ENTER]
6.3 Calibration Constant Entry
Enter the calibration constants from the sensor label or certificate. For sensor types High and
Low a Multiplier ”M” and Adder ”A” are entered.
For sensor Type 2, a Multiplier ”M” followed by a table of K and F values are entered. Pressing
[ENTER] will bring up the additional K and F factors. Press [ENTER] again to continue.