Specifications

Transmitter M300 FLOW 43
© 09 / 08 Mettler-Toledo AG, CH-8606 Greifensee, Switzerland Transmitter M300 FLOW
Printed in Switzerland 52 121 319
8.6 Display
(PATH: Menu/Configure/Display)
Enter configuration mode as described in Section 8.1.
This Menu allows for the configuration of the values to be displayed and also the configuration
of the Display itself.
8.6.1 Measurement
The Display has 4 lines. Line 1 on top and Line 4 on the bottom.
Select the values (Measurement a, b, c or d) to be displayed on each line of the display.
Select the ”Error Display” mode. If this is set to ”On” when an alarm has occurred, the message
”Failure – Press Enter” will be displayed on Line 4 when an alarm occurs in the normal
Measurement mode.
C
NOTE: Pressing [ENTER] during normal Measuring mode of four channel transmitters
will toggle the display between the Primary (A–D) and Secondary (a–d) values.
Select the ”Error Display” mode. If this is set to ”On” when an alarm has occurred, the message
”Failure – Press Enter” will be displayed on Line 4 when an alarm occurs in the normal
Measurement mode.
Pressing the [ENTER] key again will bring up the Save Changes dialog. Selecting No will
discard the entered values, selecting Yes will make the entered values the current ones.
8.6.2 Resolution
This menu allows the setting of the resolution of each displayed value.
Possible settings are 1, 0.1, 0.01, 0.001 or Auto.
Pressing the [ENTER] key Will bring up the Save Changes dialog.