Operating instructions

Dispensing functions
12 Operating instructions 22012836B 09/08
IND690-Fill
1.11 Totalizing automatically
To automatically totalize dispensing processes with the same dispensing samples,
an item counter can be specified which determines the number of dispensing
processes. When the item counter reaches its stop value, the dispensing system
stops automatically.
Prerequisite
TOTALIZING ON is set in the master mode.
1. To set the item counter:
– Press N key.
– Enter start value of item counter and confirm with ENTER.
– Enter stop value of item counter and confirm with ENTER.
2. Carry out 1st dispensing process, see section 1.6.
3. Relieve weighing platform.
4. Carry out additional dispensing processes, see section 1.6.
When the item counter reaches its stop value, the dispensing system stops
automatically.
5. To display and print the total sum, press the SUM, ENTER key sequence.
6. To carry out additional dispensing processes with the same dispensing sample,
e.g. after redispensing the supply vessel, repeat steps 1 to 3.
When doing so, make sure that the item counter continues to count.
– or –
To carry out dispensing processes with a different dispensing sample, or to end
totalizing, press the SUM, CLEAR key sequence.
Notes
• If TOTALIZING ON, CORRECT DISPENSINGS is set in the master mode, cancelled
dispensing processes can only be added to the total sum by pressing the SUM key
when CONTINUE WITH START is displayed.
• If PASSWORD BLOCK ON is set in the master mode, a personal code must be
entered after pressing the SUM and N keys.