Installation Instructions

METTLER TOLEDO
11.11.2016, mme Ver.1.0
Installation of THVMULTIRFID5X
1. Tie all wires down with Kapton tape, as shown below.
2. Mount 4 PCBs and plug coils into PCBs.
3. Plug termination resistor into marked PCB and tie down with Kapton tape.
4. Plug PicoBlade cables as shown below, and tie down with Kapton tape.
5. Plug short PicoBlade cable into connector next to termination resistor.
6. Mount plate and PCB in the middle.
7. Plug coils into PCB.
8. Plug remaining PicoBlade cables in and tie them down with Kapton tape, as shown
below.
Termination resistor