Operating instructions

The menu

4.14 Selecting the switch-on mode

You can set your balance so that it starts immediately from standby when a weight is placed on the pan or so that it must

be switched on with the «On/Off» key and then performs a display test.

The following settings are available:

Quickstart*

This is the factory setting. The balance can be started directly from standby and is

immediately ready for weighing. You can place the weight on the pan in the

standby mode and the balance immediately displays the weighing result.

*Quickstart is not possible with certified balances.

Start with display test

You must switch on the balance with the «On/Off» key. After the balance has been

switched on, it performs a display test during which all display segments light up

briefly. On completion of the test, the balance is ready for weighing.

Note: If the balance has been separated from the power supply, it always

performs a display test after switching on, even if the “Quickstart”

setting has been selected.

qÙ StArt

FÙ StArt

4.15 Setting display of the icons

AuTo OFF

All icons appear in the display.

If desired, you can also switch off the icons. They disappear after about 10

seconds after you have quit the menu or after about 3 min. after the balance has

been switched on.