Specifications

Chapter 3: Configuring the Setup Parameters
Configuring Setup Parameters
(09/03) 3-7
Sleep Program Block
The Sleep program block lets you configure the sleep timer. Power
consumption is reduced by approximately 60% while in Sleep mode.
IMPORTANT: For battery powered units, it is important to turn battery
power off (using the rocker switch underneath the scale) when the scale is
not in use.
To configure the Sleep program block:
1. Press UNITS to display the SLEEP prompt, then press ZERO.
2. Press ZERO to display the desired sleep timer option. Options include:
• Disable—the PS15 will not power-down regardless of time between
transactions (inactivity)
• 5 min—the PS15 will enter Sleep mode after 5 minutes with no activity
3. Press UNITS to accept the sleep timer option. The PS15 continues to the
GEOCAL™ / End program block.
GEOCAL

 Program
Block
This program block lets you enable the GEOCAL™ prompt at power-up. If
this setting is enabled, the unit will prompt for the entry of a GEOCAL™ code
after setup is exited.
To configure the program block:
1. Press UNITS to display the GEo in prompt, then press ZERO.
2. Press ZERO to display the desired approval setting, enable or disable.
3. Press UNITS to accept the displayed option. The PS15 continues to the
Cal program block.
Calibration Program
Block
See Chapter 2 for detailed information about activating GEOCAL™ and
calibrating the PS15. (Metrology PCB jumper must be removed.)
End Program Block
The End program block lets you save the configuration and exit setup mode.
This program block does not have parameters to configure.
To use the End program block:
1. Press UNITS to display the End prompt.
In normal operating mode the scale
is powered-up by pressing the ZERO
(ON/OFF) key.
Power is saved if RS-232 interface is
not used.