Specifications

Chapter 2
Chapter 2Chapter 2
Chapter 2: Installation and Calibration
: Installation and Calibration: Installation and Calibration
: Installation and Calibration
Unpacking and Setup
Unpacking and SetupUnpacking and Setup
Unpacking and Setup
(03/01) 2-
(03/01) 2-(03/01) 2-
(03/01) 2-3
33
3
Incorrect
Bubble is not
within circle
Correct
Bubble is
within circle
5.
5.5.
5.
Unpack the power supply and plug it into the power jack in the scale base.
The jack is recessed on the bottom of the base toward the center front.
Plug the line cord into a
properly grounded
AC power outlet. Figure 2-d
illustrates proper power supply connection.
WARNING!
AC power sources must have proper short
circuit and over current protection in
accordance with local and national electrical
regulations. Failure to provide this may result
in bodily injury and/or property damage.
NOTE: Inside of barrel is positive.
Figure 2-c: Level Indicator
Figure 2-c: Level IndicatorFigure 2-c: Level Indicator
Figure 2-c: Level Indicator
Figure 2-d: Power Cable Connection
Figure 2-d: Power Cable ConnectionFigure 2-d: Power Cable Connection
Figure 2-d: Power Cable Connection