Specifications

Chapter 2
Chapter 2Chapter 2
Chapter 2: Installation and Calibration
: Installation and Calibration: Installation and Calibration
: Installation and Calibration
Initial Calibration using GeoCal
Initial Calibration using GeoCalInitial Calibration using GeoCal
Initial Calibration using GeoCal
(03/01) 2-
(03/01) 2-(03/01) 2-
(03/01) 2-5
55
5
Keys and Navigation
Keys and NavigationKeys and Navigation
Keys and Navigation
The PS keypad contains a UNITS key and a ZERO key:
The functions for each key
in normal operating mode
are as follows:
• UNITS
—Press UNITS to switch between the selected main units and
alternate units.
• ZERO
—Press ZERO to zero an empty scale. The reading must be within
2% of the calibrated zero.
If the scale is in Sleep mode (as defined in the Sleep program block), press
ZERO to “awaken” the scale. The scale then goes through its normal power-
up sequence and returns to normal operating mode.
The functions for each key
in setup mode
are as follows:
• UNITS
—Press and hold UNITS for up to 8 seconds to enter setup mode.
When a program block option is displayed for selection, press UNITS to
confirm the selection.
• ZERO
—Press ZERO to scroll through a list of parameter options.
I
/
0
UNITS
ZERO
Figure 2-f: UNITS and ZERO Key
Figure 2-f: UNITS and ZERO Key Figure 2-f: UNITS and ZERO Key
Figure 2-f: UNITS and ZERO Key