Specifications

Chapter 3: Configuring the Setup Parameters
Chapter 3: Configuring the Setup ParametersChapter 3: Configuring the Setup Parameters
Chapter 3: Configuring the Setup Parameters
Configuring Setup Parameters
Configuring Setup ParametersConfiguring Setup Parameters
Configuring Setup Parameters
(03/01) 3-
(03/01) 3-(03/01) 3-
(03/01) 3-1
11
1
3
33
3
Configuring the Setup Parameters
Configuring the Setup ParametersConfiguring the Setup Parameters
Configuring the Setup Parameters
This chapter discusses basic information related to PS configuration and
specific instructions on configuring each program block and operating
parameter.
Basic Setup
Basic SetupBasic Setup
Basic Setup
Information
InformationInformation
Information
The following sections describe some basic information that you will need to
know as you configure the setup parameters for the PS.
Program Block Access
Program Block AccessProgram Block Access
Program Block Access
The PS’s operational parameters are configured in setup mode through a
series of program blocks. The program blocks are accessed as follows:
1.
1.1.
1.
Press and hold the UNITS key for up to eight seconds until the message
Setup? is displayed. Release the UNITS key. When released, the PS
displays either the Pb 0 or Alt prompt indicating the first program block.
Exit Setup
Exit SetupExit Setup
Exit Setup
Exit setup mode as follows:
1.
1.1.
1.
Press UNITS to display the End prompt.
2.
2.2.
2.
Press ZERO to display the desired exit option. Exit options include:
• No—Do not exit setup mode at this time.
• Save—Save all changes program block parameters then exit setup
mode.
• Abort—Exit setup mode but do not save any changes made in this
session.
• Various Defaults—Reset all program block parameters to a pre-
specified set of values, then exit setup mode. For details, refer to the
End Program Block section.
3.
3.3.
3.
Press UNITS to carry out the displayed option. The PS automatically exits
setup mode and returns to normal operating mode unless No is selected.
There are two alternate ways to exit the setup mode: