Specifications

Chapter 3: Configuring the Setup Parameters
Chapter 3: Configuring the Setup ParametersChapter 3: Configuring the Setup Parameters
Chapter 3: Configuring the Setup Parameters
Configuring Setup Parameters
Configuring Setup ParametersConfiguring Setup Parameters
Configuring Setup Parameters
(03/01) 3-
(03/01) 3-(03/01) 3-
(03/01) 3-7
77
7
• Proto 2 (Weightronix SC-320 com. set) • Proto 6 (Airborne
command set)
• Proto 3 (Weightronix 3870 com. set) • Disable(turns off
communications)
3.
3.3.
3.
Press UNITS to accept the protocol option. The PS continues to the Sleep
program block.
Note: Protocols 1-6 are not available on the PS6L.
Sleep Program Block
Sleep Program BlockSleep Program Block
Sleep Program Block
The Sleep program block lets you configure the sleep timer. Power
consumption is reduced by approximately 60% while in Sleep mode.
IMPORTANT: For battery powered units, it is important to turn battery
power off (using the rocker switch underneath the scale) when the scale is
not in use.
To configure the Sleep program block:
1.
1.1.
1.
Press UNITS to display the SLEEP prompt, then press ZERO.
2.
2.2.
2.
Press ZERO to display the desired sleep timer option. Options include:
• Disable—the PS will not power-down regardless of time between
transactions (inactivity)
• 5 min—the PS will enter Sleep mode after 5 minutes with no activity
3.
3.3.
3.
Press UNITS to accept the sleep timer option. The PS continues to the
GEOCAL™ / End program block.
GeoCal Program Block
GeoCal Program BlockGeoCal Program Block
GeoCal Program Block
This program block lets you enable the GEOCAL™ prompt at power-up. If
this setting is enabled, the unit will prompt for the entry of a GEOCAL™
code after setup is exited.
To configure the program block:
1.
1.1.
1.
Press UNITS to display the GEo in prompt, then press ZERO.
2.
2.2.
2.
Press ZERO to display the desired approval setting, enable or disable.
3.
3.3.
3.
Press UNITS to accept the displayed option. The PS continues to the Cal
program block.
Calibration Program
Calibration ProgramCalibration Program
Calibration Program
Block
BlockBlock
Block
See Chapter 2 for detailed information about activating GEOCAL™ and
calibrating the PS. (Metrology PCB jumper must be removed.)
Power is saved if RS-232 interface is
not used.
In normal operating mode the scale
is powered-up by pressing the ZERO
(ON/OFF) key.