Specifications

METTLER TOLEDO PS Shipping Scale Technical/Operators Manual
METTLER TOLEDO PS Shipping Scale Technical/Operators ManualMETTLER TOLEDO PS Shipping Scale Technical/Operators Manual
METTLER TOLEDO PS Shipping Scale Technical/Operators Manual
(03/01)
(03/01)(03/01)
(03/01)4-2
4-24-2
4-2
Parcel Weighing
Parcel WeighingParcel Weighing
Parcel Weighing
Before weighing parcels on the PS, please be sure the scale is configured as
desired (Chapter 3) and power is applied as instructed in Chapter 2 of this
manual.
To weigh a package:
1.
1.1.
1.
Press ZERO to capture zero. The display reads 0.00 and a cursor appears
above the zero indicator in the legend.
2.
2.2.
2.
Place the parcel to be weighed on the platter. The display reads the parcel
weight with a cursor above the current weight units legend.
3.
3.3.
3.
Record the parcel weight, then remove the parcel from the platter.
Unit Switching
Unit SwitchingUnit Switching
Unit Switching
The PS lets you view the displayed scale weight in primary and secondary
units. Alternate units must be configured (in setup mode) to convert and
display in alternate units.
To switch units:
1.
1.1.
1.
With scale weight displayed, press the UNITS key. The PS automatically
converts the displayed weight to weight in the alternate unit as indicated
by the cursor.
2.
2.2.
2.
Press UNITS again to reconvert alternate units back to primary units and
return weight display to the primary unit.
Zeroing the Scale
Zeroing the ScaleZeroing the Scale
Zeroing the Scale
Periodically the PS scale may need to be re-zeroed. Press ZERO to capture
zero. The scale will re-zero provided the weight is within 2% of the scale
capacity. The PS display will read 0.00
If primary and alternate units are the
same (as configured in the Alternate
Units program block), unit switching
is effectively disabled. The UNITS key
displays the same weight and unit
when the UNITS key is pressed.
If zero change exceeds the 2% limit,
the scale will not capture zero. In this
case, cycle power or recalibrate.
You may wish to recapture zero
periodically when the scale is in
continuous use. It is not necessary to
press ZERO before each transaction.