User's Manual
Table Of Contents
- Table of Contents
- 1 Introduction
- 2 Safety information
- 3 Design and Function
- 4 Installation
- 4.1 Standard equipment
- 4.1.1 Scope of delivery
- 4.1.2 Unpack the titrator
- 4.1.3 Position the titrator
- 4.1.4 Adjust the angle of the terminal
- 4.1.5 Connect and disconnect the terminal
- 4.1.6 Connect the titrator to the power supply
- 4.1.7 Disconnect the titrator from the power supply
- 4.1.8 Set up the titrator for a general titration
- 4.1.8.1 Attach the titration stand to the titrator
- 4.1.8.2 Swivel the titration stand
- 4.1.8.3 Attaching and removing the titration vessel
- 4.1.8.4 Recommended positions for sensors, tubes and stirrers
- 4.1.8.5 Connect the compact stirrer
- 4.1.8.6 Connect the measuring electrode
- 4.1.8.7 Attaching the electrode arm
- 4.1.8.8 Insert and connect a burette
- 4.1.9 Connect a Rondolino TTL sample changer
- 4.1 Standard equipment
- 5 Operating the instrument
- 6 Transporting the titrator
- 7 Care and maintenance
- 8 Disposal
- 9 Technical data
4.1.8.1 Attach the titration stand to the titrator
ยง
The spacing ring, clamping ring and threaded ring are mounted on the titration stand.
1 Remove the cover from one of the mounting holes.
2 Position the titration stand over the uncovered
mounting hole.
3 Place the screw in the hole of the titration stand and
screw it in the mounting hole.
4 Tighten the screw.
4.1.8.2 Swivel the titration stand
The titration stand can be swivelled among three predefined positions. If you use a compact stirrer, use the
titration stand in the swivelled out position.
1 Pull the titration stand upward out of the holder until
you feel resistance.
2 Swivel the titration stand to the desired position.
3 Slide the titration stand down until it rests on the
holder.
19Titration Excellence