User's Manual
Table Of Contents
- Table of Contents
- 1 Introduction
- 2 Safety information
- 3 Design and Function
- 4 Installation
- 4.1 Standard equipment
- 4.1.1 Scope of delivery
- 4.1.2 Unpack the titrator
- 4.1.3 Position the titrator
- 4.1.4 Adjust the angle of the terminal
- 4.1.5 Connect and disconnect the terminal
- 4.1.6 Connect the titrator to the power supply
- 4.1.7 Disconnect the titrator from the power supply
- 4.1.8 Set up the titrator for a general titration
- 4.1.8.1 Attach the titration stand to the titrator
- 4.1.8.2 Swivel the titration stand
- 4.1.8.3 Attaching and removing the titration vessel
- 4.1.8.4 Recommended positions for sensors, tubes and stirrers
- 4.1.8.5 Connect the compact stirrer
- 4.1.8.6 Connect the measuring electrode
- 4.1.8.7 Attaching the electrode arm
- 4.1.8.8 Insert and connect a burette
- 4.1.9 Connect a Rondolino TTL sample changer
- 4.1 Standard equipment
- 5 Operating the instrument
- 6 Transporting the titrator
- 7 Care and maintenance
- 8 Disposal
- 9 Technical data
4.1.8.3 Attaching and removing the titration vessel
Attaching the titration vessel
§
The titration stand is swivelled out.
1 Turn the threaded ring a quarter to a half turn clockwise.
2 Guide the titration vessel upward(1) into the titration stand and
hold the titration vessel in place.
3 Tighten the threaded ring(2).
4 Check that the titration vessel is firmly attached before you let it go.
Removing the titration vessel
§
The titration stand is swivelled out.
1 Hold the titration vessel with one hand.
2 Turn the threaded ring a quarter to a half turn clockwise(1).
3 Pull the titration vessel downward(2) out of the titration stand.
4.1.8.4 Recommended positions for sensors, tubes and stirrers
1
Dispensing tube
1
2
3
4
6
7
8
5
2
Sensor
3
Sensor or rinsing unit
4
Sensor
5
Compact stirrer
6
Dispensing tube
7
Sensor
8
Dispensing tube
4.1.8.5 Connect the compact stirrer
Depending on the configuration of the titrator, three or more compact stirrers can be connected. Compact
stirrers attached directly to the titrator can be used in the manual titration stand or in connection with sample
changers. The titrator controls turning on and off and stirrer speed.
1 Shut down the titrator.
20 Titration Excellence