User's Manual
Table Of Contents
- Table of Contents
- 1 Introduction
- 2 Safety information
- 3 Design and Function
- 4 Installation
- 4.1 Standard equipment
- 4.1.1 Scope of delivery
- 4.1.2 Unpack the titrator
- 4.1.3 Position the titrator
- 4.1.4 Adjust the angle of the terminal
- 4.1.5 Connect and disconnect the terminal
- 4.1.6 Connect the titrator to the power supply
- 4.1.7 Disconnect the titrator from the power supply
- 4.1.8 Set up the titrator for a general titration
- 4.1.8.1 Attach the titration stand to the titrator
- 4.1.8.2 Swivel the titration stand
- 4.1.8.3 Attaching and removing the titration vessel
- 4.1.8.4 Recommended positions for sensors, tubes and stirrers
- 4.1.8.5 Connect the compact stirrer
- 4.1.8.6 Connect the measuring electrode
- 4.1.8.7 Attaching the electrode arm
- 4.1.8.8 Insert and connect a burette
- 4.1.9 Connect a Rondolino TTL sample changer
- 4.1 Standard equipment
- 5 Operating the instrument
- 6 Transporting the titrator
- 7 Care and maintenance
- 8 Disposal
- 9 Technical data
2 Safety information
• Read and understand the information in this User Manual before you use the instrument.
• Keep this User Manual for future reference.
• Include this User Manual if you pass on the instrument to other parties.
If the instrument is not used according to the information in the Operating Instructions or if it is modified, the
safety of the instrument may be impaired and Mettler-Toledo GmbH assumes no liability.
For a comprehensive description of the instrument and its functions, refer to the Operating
Instructions, supplied as PDF file on the CD.
2.1 Definition of signal words and warning symbols
Safety notes are marked with signal words and warning symbols. These show safety issues and warnings.
Ignoring the safety notes may lead to personal injury, damage to the instrument, malfunctions and false
results.
Signal words
WARNING
for a hazardous situation with medium risk, possibly resulting in death or severe
injury if not avoided.
CAUTION
for a hazardous situation with low risk, resulting in minor or moderate injury if not
avoided.
NOTICE
for a hazardous situation with low risk, resulting in damage to the instrument, other
material damage, malfunctions and erroneous results, or loss of data.
Warning symbols
Electrical shock
Hot surface
2.2 Product-specific safety notes
Intended use
This instrument is designed to be used in laboratories by trained staff. The instrument is suitable for the
processing of reagents and solvents.
Any other type of use and operation beyond the limits of technical specifications without written consent from
Mettler-Toledo GmbH is considered as not intended.
This device complies with Industry Canada licence-exempt RSS standard(s) and part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation of the
device. Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
Responsibilities of the instrument owner
The instrument owner is the person that uses the instrument for commercial use or places the instrument at
the disposal of the staff. The instrument owner is responsible for product safety and the safety of staff, users
and third parties.
METTLER TOLEDO assume that the instrument owner provides the necessary protective gear, appropriate
training for the daily work and for dealing with potential hazards in their laboratory.
4 Titration Excellence