Service manual

ECONOMY COUNTING SCALE
11
If you know the APW. . .
If you know the APW of your goods, the APW can be entered directly instead of sampling.
Place the goods on the scale (e.g. 0.05 lb). Press the key
and enter the APW (e.g. 0.002 lb) of one
piece. The QTY window displays “Single” and the entered APW is displayed in the APW window. Press
to confirm. The QTY window displays now the total quantity of pieces (e.g. 25).
You may press the key
to correct or clear the input figure.
ACCUMULATION AND RECALL
The key
can be used to keep the quantity in the memory. The cursor ‘M’ is lit when the accumulated
quantity is not zero. The Wt window displays ‘Total’ and the APW window displays accumulation times
(e.g. 3 times). The QTY window displays the accumulated quantity (e.g. 1500 pcs).
Press
to confirm, then the quantity of goods on the scale into memory (e.g. 500 pcs).
To clear the accumulation, press
and the cursor “M” will be off.
Press to recall the total quantity and accumulation times (e.g. 2000 pcs, 4 times). Press to exit
recall.
When the accumulated quantity is above 999,999, the QTY window displays “nnnnnn” to indicate that
maximum number of accumulations has been reached.
.
If the weight on the scale hasn’t been changed between two accumulations, the QTY window will display
‘Again’ to refuse the operation.
ALARM
The alarm function includes a weight and a quantity alarm. Both alarms can either be set to sound within a
defined range or over/under a defined range. The alarm function can be activated in the Setup Mode
(F4/F4.1/F4.2/F4.3).