Service manual

ECONOMY COUNTING SCALE
9
OPERATING YOUR SCALE
ZERO
Press to capture a new center of zero if the scale is in gross weight mode and the weight on the scale is
stable (e.g. 0.5000 lb, as above shown, the cursor ‘Stab’ is on). The cursor “0” is lit when a new center of
zero is captured.
TARE
Pressing the
key subtracts the weight of the object on the scale platform from subsequence indications
of weight. Tare is most often used to subtract the weight an empty container. The
key is used as well to
clear a previously entered tare value if the scale is in net mode.
Direct Tare
Press the key in gross weight mode when the weight on the scale is above zero (e.g. 0.5000 lb as
above shown) to tare the scale. If a net center of zero can be captured, the cursor ‘Net’ is on. By pressing the
key
again, the scale will be back in gross weight mode. The tare range is the full capacity of the scale.
Input Tare (Digit Tare)
If the Function F3 in the Setup Mode is set to 1 (F3=1, see Setup Mode), the scale can be tared manually
without weighing-in the tare value. Press the key
to enter a tare value. The QTY window displays
“InTare” to remind you to enter the tare. The input tare is displayed in the APW window and can be corrected
by pressing the key
if a wrong figure is entered. By pressing the key , you confirm the input tare
value. The display shows the negative tar value in the weight window with the cursor “Net” on.
The input tare can be cleared by pressing the key again, and the scale is then back to gross weight
mode.