Instruction manual

114
ķ
3.5 Auto OFF for the flash unit
To save battery power and prevent inadvertent battery drain, the flash unit is
factory-set to automatically switch to standby mode (Auto OFF) 10 minutes after
• being switched on,
• a flash is fired
• the shutter release is actuated
• the camera’s exposure metering system is switched off.
...The flash readiness indicator and the LC display are also switched off.
If the flash is manually switched on again, the last settings prior to the automatic
switch off are retained and immediately available. The flash unit can be reactivated
by pressing any button or by lightly depressing the shutter release (wake up func-
tion).
The flash unit should always be turned off using the main switch

if it
is not going to be used for an extended period.
If necessary, the Auto OFF function can be set to occur after 1 minute of inactivi-
ty, or can be deactivated (see 7.10).
4 Display illumination
Every time a button on the flash unit is pressed, the flash display illumination is
activated for 10 seconds. When a flash is fired via the camera or a hand
release, the display lightning

on the flash unit is switched off.
☞
5 Operating modes (mode menu)
The flash unit supports , P
,
automatic , manual , SB and stro-
boscope modes .
Depending on the type of camera, other flash modes may be supported.
These flash operating modes can be selected and activated in the mode
menu following a data transfer with the camera. Depending on the
system, some camera models (depending on the camera's operating
mode) only support the TTL-/P-TTL flash mode. Other flash modes (auto-
matic A, manual M etc.) cannot be selected or activated!
5.1 Adjusting procedure for flash operating modes
• Press the button until the word „Mode“ appears on the display. You
can choose from the following operating modes:
TTL flash mode
P P-TTL flash mode
P HSS High speed flash mode P-TTL-HSS
Automatic flash mode
Manual flash mode
Stroboscope flash mode
SB Spot beam mode „SB“
• Set the flash mode of your choice ( , automatic
, manual , etc.) using the
and keys. The flash mode you choose is
then highlighted. The settings take effect immediately.
• Press the button , and the display changes back
to the normal view. If the button is not pressed,
the display will change back to the normal view after
about 5 seconds.


MA
TTL
M
A
TTL
TTL
TTL
Mode
☞
MATTLTTL
Mode TTL
A
M


Set
A
☛
709 47 0237.A1 58AF-2 Pen/Sam 27.07.2010 15:17 Uhr Seite 114