Instruction manual

124
ķ
• The first shot is taken without a correc-
tion value. „FB 1“ will also appear on
the display.
• The second shot is taken with minus cor-
rection. „FB 2“ and the minus correction
value (EV) will also appear on the
display.
• The third shot is taken with plus correction. „FB 3“ and the plus correction
value (EV) will also appear on the display.
• After the third shot, the flash bracketing series is automatically deleted. „FB“
will disappear from the display.
When the flash bracketing series is set, the correction value is always
shown as a positive value!
Flash bracketing series in the TTL/P-TTL flash mode
A flash bracketing series in the TTL flash mode is only possible if the camera
supports the setting of a manual flash exposure correction on the flash unit (see
camera instruction manual)! Otherwise, the shots are taken without a correction
value!
Flash bracketing in automatic flash mode A
The type of camera is not important for a flash bracketing series in automatic
flash mode A.
7.4 Extended Zoom Mode (Zoom Ext)
In the extended zoom mode, the focal length of the main reflector is reduced to
one level below the focal length of the camera lens. The resulting broader light
coverage provides additional dispersed light (reflections) inside rooms so that a
softer flash illumination is possible.
☞
Example:
The focal length of the camera lens is 50 mm. The extended zoom mode sets a
35 mm reflector position on the flash unit. However, 50 mm continues to be
shown on the display.
• When „Ext ON“ is displayed, the extended zoom mode is activated.
• When „Ext OFF“ is displayed, the extended zoom mode is deactivated.
Setting procedure:
• Press the button repeatedly until „Select“
appears on the display.
• Select the menu option „ZoomExt“ by pressing the
and keys. The selected menu option will be
highlighted.
• Confirm the selection of the special function by pres-
sing the button.
• Select the desired setting with the and
keys. The setting takes effect immediately.
• Press the button repeatedly until the screen is
reset to its normal view. If the button is not pres-
sed, the display is automatically reset to its normal
view after about 5 seconds.
Once the extended zoom mode is activated,
„EZoom“ will appear on the display next to
the focal length.
Depending on the system, the extended zoom mode is supported for lens
focal lengths of 28 mm or more (35mm format).
☞


Set


Sel
P F 5.1
AZoom 28
7.7 m ISO 100
FB1TTL
FB1
P F 5.1
AZoom 28
7.7 m EV–
1
/3
FB2TTL
EV–
1
/3
Select KEYLOCK
m/ft
Zoom Ext


Set
☛
☛
Ext OFF/ON


Set
☛
P F 5.6
EZoom 35
10 m ISO 200
TTL
EZoom
709 47 0237.A1 58AF-2 Pen/Sam 27.07.2010 15:17 Uhr Seite 124