Instruction manual

126
ķ
7.7 Meter-Feet changeover (m/ft)
The maximum flash range indicated by the flash unit’s display can either be
shown in meters or feet. The setting can be adjusted under the menu option
m/ft.
Setting procedure:
• Press the button repeatedly until „Select“
appears on the display.
• Select the „m/ft“ menu option by pressing the
and keys. The selected menu option will be
highlighted.
• Confirm the selection of the special function by pres-
sing the button.
• Select the desired setting with the and
keys. The setting takes effect immediately.
– When „m“ is displayed, distances will be shown in
meters.
– When „ft“ is displayed, distances will be shown in
feet.
• Press the button repeatedly until the
display is reset to its normal state. If the
button is not pressed, the display is
automatically reset to its normal view
after about 5 seconds.


Set


Sel
7.8 Secondary reflector
The secondary reflector i is used for frontal brightening in the case of indirect
lighting when the main reflector is pivoted to the side or upwards (see 11.3).
If the secondary reflector

produces too much light, it can be reduced:
• „ Off“ setting: Secondary reflector is turned off.
• „ P1 / 1“ setting: secondary reflector is operating at full light output.
• „ P1 / 2“ setting: secondary reflector is operating at 1/2 light output.
• „ P1 / 4“ setting: secondary reflector is operating at 1/4 light output.
When the secondary reflector is activated and the setting is saved, a symbol
will appear in the display.
Depending on the camera model, the preflash function for reducing the
red-eye effect is performed by the preflashes from the secondary reflec-
tor even if this isn't activated!
Setting procedure:
• Press the button repeatedly until „Select“
appears on the display.
• Select the menu option by pressing the and
buttons. The selected menu option will be high-
lighted.
• Confirm the selection of the special function by pres-
sing the button.
• Select the desired setting with the and but-
tons. The setting takes effect immediately.
• Press the button repeatedly until the display is
reset to its normal state. If the button is not pres-
sed, the display is automatically reset to its normal
view after about 5 seconds.
Please also refer to the information in
Section 11.3!
☞


Set


Sel
☞
Select Zoom Ext
AF-BEAM
m/ft


Set
☛
☛
m


Set
☛
P F 4.5
AZoom 70
14 m ISO 200
TTL
m
Select
Beep
Mode Para Sel
☛
1/1


Set
☛
P F 4.5
AZoom 70
14 m ISO 200
TTL
709 47 0237.A1 58AF-2 Pen/Sam 27.07.2010 15:17 Uhr Seite 126