Instruction manual

121
ķ
Camera without integrated flash unit
Controller/Master
Camera with integrated flash unit
• Mount future controller flash unit on camera
(flash unit may not be manually switched to slave mode!)
• Set camera to “WL” mode
• Press the shutter release
- the flash unit switches automatically to “CTRL “
Instructions: If the flash unit does not switch to “CTRL ”, but to “SLAVE” instead, then the camera does not support the controller function of the external flash
unit.
Setting remote mode:
The remote mode „CTRL “ supports the slave groups RMT and RMT 2 and the controller function M (Master). The selection of the settings for these functions is
made with the button. To do so, press the button repeatedly until the symbol for the desired function is displayed. The desired mode can now be
set with the button. The setting is immediately effective and automatically saved. The light conditions in the remote system can then also be set (see
“General”).
Mode
ParaPara
+
+
+
• Press the key repeatedly until "Select" appears on the display.
• Use the and keys to select the menu item "Remote". The selected menu item will be highlighted with a dark bar.
• Press the key to confirm the selection of "Remote"..
• Use the and keys to select "Remote Slave" or "Remote OFF" to deactivate Remote Mode. The setting will take effect immediately.
• Press repeatedly until SLAVE appears on the display. If the key is not pressed, the display will automatically switch back to SLAVE after approx.
5 seconds.
• The slave flash unit then automatically recognises the function “CTRL” or “CTRL “.
+


Set


Sel
CTRL mode
+
In the “ CTRL ” mode, the slave flash units can work in two slave groups “RMT” and “RMT2”. The light conditions can be set. The controller flash
unit (master) on the camera assumes the control.
+
Slave
709 47 0245.A1 58 AF-2 Sony 27.08.2010 11:16 Uhr Seite 121