Instruction manual

123
ķ
Setting procedure:
• Press the button until „Mode“ flashes on the
LC display.
• Choose the flash mode using the and
arrows. The flash mode is then highlighted. The
setting takes effect immediately.
• Press the button to change the LC display back to
the normal view. If the button is not pressed, the
display will change back to the normal view after
about 5 seconds.
Strobe number of flashes (N)
In strobe mode, the number of flashes per shot (N) can be selected.
The number of flashes can be set from 2 to 50 in intervals of one. The maximum
manual partial light output is automatically adjusted to this number.
Strobe flash frequency (f)
Strobe mode allows you to select the flash frequency (f), which indicates the
number of flashes per second. The number of flashes can be set from 2 to 50 in
intervals of one. The maximum manual partial light output is automatically adju-
sted to this number.


Mode
Setting procedure:
• Press the button (Parameters) until the desired
flash parameter (N or f) flashes on the LC display.
• Set the desired value using the and but-
tons. The setting takes effect immediately.
• Press the button to change the LC display back
to the normal view. If the button is not pressed,
the display will change back to the normal view after
about 5 seconds.
The maximum possible partial light output depends on the ISO and aperture set-
tings, and is automatically set in strobe mode. If you desire short flashes, you
can manually reduce the partial light output to the lowest value of 1/256.
The mecablitz LC display will indicate the flash-to-subject distance required for a
correct flash exposure, given the parameters selected. By changing the aperture
setting or the partial light output, this value can be adjusted to fit the actual
distance to the subject.
Setting procedure:
• Press the button (Parameters) until the desired
flash parameter
(F=f-stop or P=partial light output) appears on the
LC display.
• Set the desired value using the and but-
tons. The setting takes effect immediately.
• Press the button to change the LC display back to
the normal view. If the button is not pressed, the
display will change back to the normal view after
about 5 seconds.
Aperture and ISO settings do not appear on the
LC display in strobe mode. Strobe mode may not
be combined with an operational second reflec-
tor.
☞
–
+
Para
–
+
Para
Mode A
M


Set
☛
Mode Para Sel
N24:f10
Hz
AZoom 24
1.2 m P1/32
Para –
+
N24
2.1 m
☛
☛
Para –
+
2.1 m P1/32
F 4.0
MZoom 24
4,6 m P1/1
☛
☛
Para –
+
709 47 0159.A1 58AF-2 Ni Print 26.07.2010 14:13 Uhr Seite 123