Instruction manual

126
ķ
6.4 Flash exposure correction (EV)
Manual flash exposure correction (EV) can help offset extreme differences in
contrast between the subject and background. Corrections from -3 f-stops (EV)
to +3 f-stops (EV) can be made, in 1/3 increments (also see 10.5).
Setting procedure:
• Press the button (Parameters) until „EV“ flas-
hes on the LC display.
• Set the desired EV value using the and but-
tons. The setting takes effect immediately.
• Press the button to change the LC display back to
the normal view. If the button is not pressed, the
display will change back to the normal view after
about 5 seconds.
–
+
Para
6.5 Light sensitivity (ISO)
If there is no digital data transfer between the camera and flash unit, for exam-
ple with cameras from Group A (see table 1) or when using non-CPU–capable
lenses, the ISO can be manually set from 6 to 6400.
For flash modes (automatic) and (manual), the camera and flash unit
have to be set to the same ISO value.
Setting procedure:
• Press the button (Parameters) until „ISO“ flas-
hes on the LC display.
• Set the desired ISO value using the and
buttons.
The setting takes effect immediately.
• Press the button to change the LC display back to
the normal view. If the button is not pressed, the
display will change back to the normal view after
about 5 seconds.
During TTL flash mode, setting the ISO on the flash unit is only necessary to
achieve the correct distance range indication, not for the function of the flash.
–
+
Para
MA
F 8.0
MZoom 35
12 m EV 0
A
Para –
+
☛
F 8.0
MZoom 35
6,1 m EV+2
A
Para –
+
☛
F 8.0
MZoom 35
17 m ISO 400
A
Para –
+
☛
F 8.0
MZoom 35
12 m ISO 200
A
Para –
+
☛
709 47 0159.A1 58AF-2 Ni Print 26.07.2010 14:13 Uhr Seite 126