Instruction manual

131
ķ
7.6 Cordless remote mode (Remote)
• When „Remote OFF“ appears, the cordless remote mode is deactivated.
• When „Remote Master“ appears, the flash unit is operating as a guiding
master flash unit on the camera.
• When „Remote Slave“ appears, the flash unit is operating completely as a sla-
ve flash unit. See also Section 21.
Setting procedure:
• Press the button repeatedly until „Select“
appears on the display.
• Select the „Remote“ menu option by pressing the
and buttons. The selected menu option will
be highlighted.
• Confirm the selection of the special function by pres-
sing the button.
• Select the desired setting with the and but-
tons.
The setting takes effect immediately.
• Press the button repeatedly until the screen is
reset to its normal view. If the button is not pres-
sed, the display is automatically reset to its normal
view after about 5 seconds.


Set


Sel
7.7 Meter-Feet changeover (m/ft)
The maximum flash range indicated by the flash unit’s display can either be
shown in meters or feet. The setting can be adjusted under the menu option
m/ft.
Setting procedure:
• Press the button repeatedly until „Select“
appears on the display.
• Select the „m/ft“ menu option by pressing the
and buttons. The selected menu option will be
highlighted.
• Confirm the selection of the special function by pres-
sing the button.
• Select the desired setting with the and but-
tons. The setting takes effect immediately.
– When „m“ is displayed, distances will be
shown in meters.
– When „ft“ is displayed, distances will be
shown in feet.
• Press the button repeatedly until the
display is reset to its normal state. If the
button is not pressed, the display is
automatically reset to its normal view
after about 5 seconds.


Set


Sel
Select BEEP
FB
Remote


Set
☛
☛
Remote
Master


Set
☛
Para Sel
CH1
TTL AZoom 28
TTL+
1
/
3
F32
B
A
M
Select Zoom Ext
AF-BEAM
m/ft


Set
☛
☛
m


Set
☛
F 4.5
AZoom 70
14 m ISO 200
A
m
709 47 0159.A1 58AF-2 Ni Print 26.07.2010 14:13 Uhr Seite 131