Instruction manual

132
ķ
7.8 Secondary reflector
The secondary reflector  is used for frontal brightening in the case of indirect ligh-
ting when the main reflector  is pivoted to the side or upwards (see 10.3).
If the secondary reflector

produces too much light, it can be reduced to 1/2
or 1/4 .
• „ Off“ setting: Secondary reflector is turned off.
• „ P1 / 1“ setting: secondary reflector is operating at full light output.
• „ P1 / 2“ setting: secondary reflector is operating at 1/2 light output.
• „ P1 / 4“ setting: secondary reflector is operating at 1/4 light output.
When the secondary reflector is activated and the setting is saved, a symbol
will appear in the display.
Setting procedure:
• Press the button repeatedly until „Select“
appears on the display.
• Select the menu option by pressing the and
buttons. The selected menu option will be high-
lighted.
• Confirm the selection of the special function by pres-
sing the button.
• Select the desired setting with the and but-
tons. The setting takes effect immediately.
• Press the button repeatedly until the display is
reset to its normal state. If the button is not pres-
sed, the display is automatically reset to its normal
view after about 5 seconds.
Please also refer to the information
in Section 10.3!
☞


Set


Sel
7.9 Modelling Light (ML)
The modelling light is a high-frequency stroboscopic flash. It creates the impres-
sion of a semi-permanent light for a duration of about 3 seconds. The modelling
light enables the user to assess light distribution and the formation of shadows
before taking pictures.
• The modelling light is activated when „ML ON“ is displayed.
• The modelling light is deactivated when „ML OFF“ is displayed.
Setting procedure:
• Press the button repeatedly until „Select“
appears on the display.
• Select the menu option „ML“ by pressing the
and buttons. The selected menu option will be
highlighted.
• Confirm the selection of the special function by pres-
sing the button.
• Select the desired setting with the and but-
tons. The setting takes effect immediately.
• Press the button repeatedly until the screen is
reset to its normal state. If the button is not pres-
sed, the display is automatically reset to its normal
view after about 5 seconds.
Once the modelling light function is activated, the sym-
bol is displayed on the flash-ready indicator

or the manual firing button. The modelling light is acti-
vated when the manual firing button

is pressed.
When the flash unit functions as
master in the cordless remote system,
the activation of the modelling light
also activates the modelling light of slave
flash units (see 21.4).
The secondary reflector ~ is not supported by the modelling light function!
☞


Set


Sel
Select
Beep
Mode Para Sel
☛
1/1


Set
☛
F 4.5
AZoom 70
14 m ISO 200
A
Select Standby
KEYLOCK
ML


Set
☛
☛
ML
ON


Set
☛
Mode Para Sel
F 4.5
AZoom 70
14 m ISO 200
A
709 47 0159.A1 58AF-2 Ni Print 26.07.2010 14:13 Uhr Seite 132