Instruction manual

104
ķ
Setting procedure:
• Press the button until „Mode“ flashes on the
LC display.
• Set the flash mode using the and
keys. The flash mode selected is then highlighted.
The setting takes effect immediately.
• Press the button to change the LC display back to
the normal view. If the button is not pressed, the
display will change back to the normal view after
about 5 seconds.
If the shot was properly lit, the correct exposure indica-
tion

will flash „OK“ for about 3 seconds (see 13).
5.5 Automatic flash mode
When shooting in automatic fill-in flash mode in daylight, the automatic flash
mode will automatically set a correction of between -1 and -2 f-stops to
compensate for flash exposures (see 6.3 and 10.5).
This has a graduated lightening effect on shadowy areas, which has a natural
appearance on the photograph.
5.6 Manual flash mode
In the manual flash mode , the flash unit emits the full uncontrolled amount
of light if no partial light output has been selected. The specific photographic
situation can be taken into account by making adjustments to the aperture set-
ting or by selecting a suitable partial light setting.
M
A


A
Mode
Setting procedure:
• Press the button until „Mode“ flashes on the
LC display.
• Choose the flash mode using the and
arrows. The flash mode M is then highlighted.
The setting takes effect immediately.
• Press the button to change the LC display back to
the normal view. If the button is not pressed, the
display will change back to the normal view after
about 5 seconds.
Set partial light output:
• Press the button until „P“ flashes on the
LC display for partial light output.
• Set the desired light output (1/1-1/256) with the
or buttons.
The setting takes effect immediately.
• Press the button to change the LC display back to
the normal view. If the button is not pressed, the
display will change back to the normal view after about 5 seconds.
The mecablitz LC display will indicate the flash-to-subject distance required for a
correct flash exposure.
Some cameras only support the manual flash mode when the
camera is set to the manual operating mode M.
M
☞
–
+
Para


M
Mode
Mode TTL HSS
A
M


Set
A
☛
Mode Para Sel
AZoom 70
11 m
A
✴
Mode A
M
MHSS


Set
M
☛
Mode Para Sel
MZoom 35
11 m
M
F4.0
MZoom 35
4,1 m P1/8
M
☛
☛
Para –
+
709 47 0229.A1 58AF-2 Oly/Pana 29.07.2010 10:46 Uhr Seite 104