Instruction manual

123
ķ
• Set the desired value using the / buttons. The setting takes effect
immediately.
• Press the button to change the LC display back to the normal view. If the
button is not pressed, the display will change back to the normal view
after about 5 seconds.
–
+
6.2 Aperture (F)
If there is no digital data transfer between the camera and flash unit, the apertu-
re can be set by hand from 1.0 to 45 (at ISO 100), in intervals of one full aper-
ture. For flash modes A (automatic) and M (manual), the camera and flash unit
have to be set to the same aperture.
Setting procedure:
• Press the button (Parameters) until „F“ flashes
on the LC display.
• Set the desired value using the / buttons.
The setting takes effect immediately.
• Press the button to change the LC display back
to the normal view. If the button is not pressed,
the display will change back to the normal view after
about 5 seconds.
During digital data transfer between the camera and flash unit, interme-
diate values are also adjusted. During TTL-/E-TTL-flash mode, setting the
aperture on the flash unit is only necessary to achieve the correct distance
range indication, not for the function of the flash.
☞
–
+
Para
—
TTL/E-TTL/A/E-TTL-HSS
—
—
F
Zoom
EV
ISO
—
M/M HSS
—
P
F
Zoom
—
ISO
N
Number of strobe flashe
Table 1
Strobe flash frequency
Manual partial light output
Aperture
Mainreflektor position
Manual flash exposure correction
Light sensitivity
f
P
F
Zoom
—
ISO
Mode Para Sel
F 4.0
AZoom 70
7,7 m ISO 200
A
☛
F 8.0
AZoom 70
3,8 m ISO 200
A
Para –
+
☛
709 47 0210.A1 58 AF-2 Canon 29.07.2010 10:21 Uhr Seite 123