User Manual

152
k
10.2 Controller mode settings
In remote control mode the flash of the controller
flash unit only assumes the control function and
does not contribute to exposure of the shot!
10.2.1 Controller mode settings
• Switch on the flash unit with the

button. The start screen appears.
• Press the  button and the drop-down
menu will appear.
• Use the  buttons to select the
operating mode.
• Press the
°  button and confirm the selected
operating mode.
Remote control mode is set.
CONTR.
10.2.2 Controller channel settings
There are four independent remote channels to use
so that multiple remote systems in the same room
do not interfere with one another. Control and Slave
flash units belonging to the same remote system
must be set to the same remote channel.
• Press the  button and the menu
will appear.
• Use the buttons  to select .
• Press the
°  button and open the menu.
• Use the  buttons to set the desired channel.
• Press the
°  button and confirm the selected
setting.
The setting will take effect immediately.
The channel setting, CH. 3 in the example, can be
checked by pressing button
°  .
OPT.
CHANNEL
MODE
MASTER
CONTR.
SLAVE
CH. 1
EV
CONTR.
OPT.
ZOOM
CHANNEL
RESET
CHANNEL
2
3
4