Operating Guide

ASSEMBLY INSTRUCTIONS
1. Remove the spreader and
components from carton and
place hopper up-side down on
a padded surface as shown.
Slide drive and free wheel
onto axle as shown with the
longer portion of wheel hub
facing the frame. Secure free
wheel with (1) 1/8 dia. x 1 1/4”
cotter pin. Attach drive wheel
to axle with (1) 3/16 dia. x 2”
cotter pin.
3. Turn spreader upright on
wheels. Insert screen into
hopper sliding it under the
screen clips. Attach the upper
handle assembly to handle
brace with the handle lever
facing as shown. Secure with
(2) 1/4-20 x 1 1/2” carriage
bolts, and locknuts. Install
control tube to handle lever
with (1) 1/4 dia. clevis pin and a
3/32” dia. cotter pin. Slip
opposite end of control tube
over lower control rod making
sure shutoff plate is between
the lower rod and the control
tube. Secure with a 3/32” dia.
Hitch pin cotter.
2. Attach leg/brace to frame as
shown using (4) 1/4-20 x 2 1/2”
carriage bolts and locknuts.
1/8 Dia. x
1 1/4” Cotter
Pin
3/16 Dia. x
2” Cotter Pin
Drive Wheel Free Wheel
Handle Brace/
Leg
1/4-20 X 2 1/2”
Carriage Bolt
NOTE POSITION OF
HANDLE LEVER
1/4-20 X 1 1/2”
Carriage Bolt
1/4-20 Locknut
Control Tube
Lower Rod
Shutoff Plate
Handle
Lever
Upper Handle
Assembly
Screen
1/4-20
Locknut
3/32” Dia.
Hitch Pin
Cotter
3/32” Dia.
Cotter Pin
1/4 Dia.
Clevis Pin