User guide

6
CHAPTER 1
Twisted Pair Network Cable
Twisted Pair Network Cable
Loudspeakers
RMS Work Station
RMS Host Software
LNS Server
RMS Database
Network Interface Driver
(1-62)
Figure 1.2. Simple twisted-pair network configuration
Twisted pair
Figures 1.2 and 1.3 show typical network configurations for
simple twisted-pair and twisted-pair repeater configurations.
When designing a twisted-pair RMS network, pay close
attention to the wiring, cable gauge, and connector
requirements (discussed in the section “Network
Specifications” later in this chapter) which are important to
good performance.
CAUTION: Consider using a repeater in
the network if you are within 1,640 feet
of exceeding the cable length or if you are using
VEAM™ connectors in your system design.
Ethernet Cat 5 Patch Cable
Twisted Pair Network Cable
RMS Work Station
RMS Host Software
LNS Server
RMS Database
Network Interface Driver
FTR-120 NETWORK
REPEATER
Loudspeakers
(1-62)
Loudspeakers
(1-62)
(1-115)
Quantity
Twisted Pair Network Cable
Twisted Pair Network Cable
Figure 1.3. Twisted-pair network configuration with repeater