Instructions / Assembly

5
If you are using extension brackets:
4. Attach the extension brackets to the legs of the spreader
frame.Usetwo5/16"x2"hexboltsand5/16"nylock
nuts per bracket. Tighten.Seegure4.
5/16" NYLOCK
NUT
MOUNTING
BRACKET, R.H.
5/16" x 2-3/4"
HEX BOLT
If you are using extension brackets:
5. Attach the R.H. mounting bracket to the extension bracket
showningure5usingtwo5/16"x1"hexboltsand
5/16"nylocknuts.Tighten. Repeat on the other frame
leg with the L.H. mounting bracket.
FIGURE 5
FIGURE 6
FIGURE 4
5/16" x 2"
HEX BOLT
EXTENSION
BRACKET
5/16" NYLOCK NUT
6. Attach an angle stop bracket and a swivel bracket to
the rear hole in the R.H. shield bracket using a 1/4"
x 1" hex bolt, two 1/4" washers, a nylon washer and
a 1/4" Nylock nut. Place the angle stop bracket on
inside and swivel bracket on outside. Tighten locknut
so the swivel bracket can pivot freely. See gure 12.
Repeat step on L.H. shield bracket.
7. Attach a swivel bracket to front hole in the R.H. shield
bracket using a 1/4" x 1" hex bolt, two 1/4" washers,
a nylon washer and a 1/4" Nylock nut. Tighten the
nut so that the swivel bracket can pivot freely. See
gure 12. Repeat step on L.H. shield bracket.
SWIVEL
BRACKET
ANGLE STOP
BRACKET
1/4" x 1"
HEX BOLT
1/4"
WASHER
1/4" NYLOCK
NUT
NYLON
WASHER
SHIELD
BRACKET
NYLON
WASHER
8. Assemble spreader shield to the front swivel brackets
using two 1/4" x 3/4" carriage bolts, 1/4" washers and
the two 1/4" plastic knobs. See gure 13.
9. Assemble spreader shield to the rear swivel brackets
using two 1/4" x 1" hex bolts, four 1/4" washers and
two 1/4" Nylock nuts. Tighten the nuts so that the
swivel bracket can still pivot freely. See gure 13.
FIGURE 7
1/4" x 1"
HEX BOLT
1/4" WASHER
1/4" NYLOCK NUT
PLASTIC
KNOB
1/4" x 3/4"
CARRIAGE BOLT