Instructions / Assembly

6
FIGURE 11
15. Place the motor assembly down into the hopper, inserting
the end of the spreader shaft into the impeller coupler.
Secureitwitha1/8"x1-1/4"cotterpin,spreadingthe
endsofthepinaroundthecoupler.Seegure9.
16. Fasten the motor mount bracket to the hopper using four
5/16"x1"hexbolts,5/16"atwashers,nylonwashers
and5/16"nylocknuts.Seegure9.
14. Assemble the impeller coupler onto the motor shaft and
secureitwiththesetscrewagainsttheatsideofthe
motorshaft.Seegure8.
FIGURE 10
SET SCREW
IMPELLER
COUPLER
5/16" x 1"
HEX BOLT
NYLON
WASHER
5/16" NYLOCK NUT
MOTOR
ASSEMBLY
5/16" FLAT
WASHER
1/8" x 1-1/4"
COTTER PIN
SPREADER
SHAFT
FIGURE 8
10. Attach the spreader's mounting brackets to the vehicle's
rear rack using four 5/16" x 1-3/4" carriage bolts,
mounting clamps and plastic knobs. Use the adhesive
padstoprotecttherack.Seegure6.
5/16" x 1-3/4"
CARRIAGE BOLT
MOUNTING
CLAMP
PLASTIC KNOB
MOUNTING
BRACKET
ADHESIVE PAD
IMPELLER
1/8" x 1-1/4"
COTTER PIN
1/8" HAIRPIN
AGITATOR
SPREADER
SHAFT
FIGURE 9
11. Insertthe1/8"hairpinagitatorintothemiddleholein
thespreadershaft.Seegure7.
12. Slide the end of the spreader shaft through the plastic
bushinginthebottomofthehopper.Seegure7.
13. Slide the impeller onto the spreader shaft and secure
itwitha1/8"x1-1/4"cotterpin.Seegure7.