Instructions / Assembly

7
FIGURE 13
FIGURE 12
FIGURE 14
WIRING INSTRUCTIONS
When properly connected, the spreader motor and impeller
will run clockwise viewed from above.
18. Movethespreader'sowcontrollevertotheoffposition
sothatthe"ON-Off"switchisturnedoff.
19. Connecttheshort(fused)wireharnesstothevehicle
battery by connecting the red wire to the positive post
and the brown wire to the negative post on the battery.
The wire harness may be left permanently attached to
thebattery.Seegure12.
20. Connect the long wire harness to the spreader by
connecting the red and white wires to the switch and
the brown and white wires to the spreader motor. Refer
togure12.
21. Connectthelongwireharnesstotheshort(fused)wire
harness. Be sure the wires are clear of any moving parts,
hot engine parts, or pinch points.
22. Use the nylon ties provided to safely secure the wiring
away from hot engine parts, rotating parts and pinch
points.
17. Attachtheowcontroltothemotormountbracketonthe
spreaderusingthe5/16"x1"carriagebolt,amounting
clampandaplasticknob.Seegure11.
NOTE:Youcanalsoattachtotherearrackifyouusea5/16"
x1-3/4"carriagebolt.Ifyouattachtotherearrack,youcan
looselypre-assembletheclamp,boltandknobtotheow
control. The clamp can then be angled down through the
slot in the rack.
NEVER allow negative pin on plug to come
incontactwithpositive"hot"postonbattery.
Fire or explosion can result!
"ON-OFF"
SWITCH
FLOW CONTROL
ON-OFF
23. Movetheowcontrol levertothe"ON"position.Flip
the "ON-OFF" switch on and check that the motor
runs counterclockwise. If it does not, refer to the wiring
diagram on page 6 and recheck the hookup.
24. Movetheowcontrolleverto"OFF".Thisshouldturn
the"ON-OFF"switchoff.Ifitdoesnot,youcanloosen
thecontrol androtate itenough thattheowcontrol
lever,whenmovedtothe"OFF"positionwillturnthe
switchoff.Seegure13.
BROWN
RED
FUSE AND HOLDER
POSITIVE
"HOT" POST
NEGATIVE PIN
BROWN
RED
BATTERY
+
SWITCH
MOTOR
BROWN
RED
WHITE
5/16" x 1"
CARRIAGE
BOLT
MOUNTING
CLAMP
PLASTIC KNOB
5/16" x 1-3/4"
CARRIAGE
BOLT