Instructions / Assembly

8
FIGURE 16
IMPORTANT: Application rates shown in the chart are
affected by humidity and by the moisture content of
the material (granular and pellet). Some minor setting
adjustments may be necessary to compensate for this
condition.
OVERLAP
REFER
TO CHART
USING YOUR SPREADER
We do not recommend the use of any powdered lawn
chemicals, due to difculty in obtaining a satisfactory or
consistent broadcast pattern.
1. Determine approximate square footage of area to be
covered and estimate amount of material required.
2. Verify that the spreader motor turns on and off and that
theowcontrolisoperatingproperly.
3. Makesuretheowcontrolleverisintheoffposition
and the closure plate is shut.
4. Settheadjustablestoptothedesiredowrate,keeping
the ow control arm in the off position. Refer to the
application chart on this page and the instructions
onthefertilizerbagtodeterminetheproperowrate
setting. The application chart is calculated for a vehicle
speedof3mph(100ft.in23seconds).Fasterspeeds
requirehigherowratesettingstomaintainthesame
application rate.
5. Fill the hopper with the material to be spread, breaking
upanylumpsasyoullthehopper.
7. Start the vehicle in motion and then open the spreader
closureplateandiptheswitchto"ON".
OPERATION
HOW TO USE YOUR SPREADER
SETTING THE FLOW CONTROL
1. Slide the Adjustable stop to the desired setting.
2. Move the Flow Control Lever forward until it snaps into
the Adjustable Stop, locking the lever at the desired
setting.Seegure15.
5
1
3
7
10
OFF
FLOW CONTROL LEVER
ADJUSTABLE STOP
FIGURE 15
STARTING THE SPREADER
1. Move the Flow Control Lever against the Adjustable
Stopandipthe"ON-OFF"switchtotheonposition.
STOPPING THE SPREADER
1. MovetheFlowControlLevertothe"OFF"position.Make
sure that the switch is turned off by the Flow Control
Lever.
8. Shut the closure plate before turning or stopping.
9. To insure uniform coverage, make each pass so that the
broadcast pattern slightly overlaps the pattern from the
previouspassasshowningure16.Theapproximate
broadcast widths for different materials are shown in
the application chart on this page.
10. When broadcasting weed control fertilizers, make sure
the broadcast pattern does not hit evergreen trees,
owersorshrubs.
11. Heavy moisture conditions may require a cover over the
hopper to keep contents dry. The vinyl cover acts as a
wind and moisture shield, but should not be used as a
rain cover.
12. If fertilizer is accidentally deposited too heavily in an
area, soak the area thoroughly with a garden hose or
sprinkler to prevent burning of the lawn.
TYPE FLOW SETTING SPREAD
MATERIAL 3 MPH WIDTH
FERTILIZER
Powder 3 - 5 3' - 4'
Granular 3 - 5 10' - 12'
Pelleted 3 - 5 17' - 19'
Organic 6 - 8 3' - 4'
GRASS SEED
Fine 3 - 4 3' - 4'
Coarse 4 - 5 8' - 9'
ICE MELT 6 - 8 17' - 19'
SAND 4-10 17' - 19'
APPLICATION CHART
OPERATING SPEED -3MPH.(100ft.in23seconds)